Truper COMP-12S, Manual

7

F

C

D

E

A

B

ENGLISH

Start Up

                          • Before operating the compressor, set it in a 

flat, level and solid surface, good ventilation and away of 

flammable object, for example, curtains or drapes. Leave 12” 

free space around the compressor to allow air to circulate.

• Turn the regulator (

A

) completely in a counterclockwise 

direction to close the air flow.

• Connect the air hose to the air outlet (

B

).

• Press the ON / OFF switch (

C

) into the OFF (

O

) position.

• Connect the power cable.

• Turn ON the equipment pressing the ON / OFF switch into 

ON (

I

) position. Let the compressor run until reaching the 

pressure of the automatic switch off.

• Set the pneumatic tool in the end of the hose.

• Turn the regulator until the gaug (

D

) indicates the adequate 

pressure for the pneumatic tool. Operate following the tool 

instructions.

• As the air in the tank empties, due to the use of the 

pneumatic tool, the compressor reboots automatically to keep 

the preset pressure. When the tool is used continuously, the 

compressor will have automatic ON / OFF cycles.

• Humidity inside the tank can get condensed and 

produce droplets of water that get expelled with the 

compressed air. When humidity in the environment is high 

or when the compressor is used continuously during long 

periods of time, drain the tank constantly and install a 

humidity filter in the air hose, as close to the pneumatic 

tool or air gun as possible.

Turning ON and operation

Humidity in the compressed air

• Turn OFF the compressor pressing the ON / OFF switch 

into the OFF (

O

) position.

• Disconnect the power cable and tangle it in the handle 

to prevent damage when not in use.                               

       Never disconnect the compressor from 

the power supply to turn it OFF. If the power supply is 

accidentally interrupted, do not forget to press the switch 

OFF so the compressor is correctly turned off.

• Wear safety eyeglasses.  Release the pressure from the 

tank pulling the safety valve ring (

E

). Use your other 

hand to divert the burst of air passing in your face.

• Drain the condensation in the tank opening the drain 

valve in the bottom of the tank (

F

). Pressure in the tank 

shall be below 68,9 kPa (10 PSI) when the tank drains.

• Disconnect the air hose from the compressor and leave 

the end open and hanging to drain condensation.

• The compressor and the hose shall be stored in a fresh 

and dry place.

Turning OFF and storag

CAUTION

CAUTION