Truper LIRO-5A, Manual

7

Start up

ENGLISH

This sander was designed to sand wood, metal, plastic 

and similar materials. Can be used for repetitive sanding 

jobs and finishing. Due to its size, is ideal for final jobs.

• Before connecting the tool to the power supply, adjust 

the dust bag into the dust extraction duct in the rear or the 

sander (

D

).

• To get an optimal dust extraction, remove and empty the 

dust bag when is half-full.

• Use the dust bag when sanding wood. Do no use when 

sanding metal. The metal particles could ignite the residual 

wood dust or the inner pouch.

• Make sure to regularly clean the dust accumulated in the 

dust bag and the Velcro base. 

Dust Extraction

• Switch on the sander before setting it onto the work 

piece.

• Keep the sander base parallel to the work piece surface.

• Press lightly downwards onto the work piece. Make 

circular movements. Be sure the full sanding area is 

supported on the work piece.

• Ensure the pressure is moderated. Do not force the 

sander. Make it work at a reasonable speed. If too much 

pressure is applied, the motor speed could be slower due 

to overheating. It could cause insufficient sanding and 

damage to the motor.

• If after sanding, the surface is still showing marks, sand 

again with a coarser grain to eliminate the marks. Replace 

the sanding disc with the next one and finish sanding. Or, 

replace the worn sanding disc with a new one.

• Do not let the sanding disc be totally worn out. Replace it 

before this happens.

Sander Operation

D