TRUST 240H EASY WEBSCAN GOLD
2
3 Installation
3.1
Uninstalling old drivers and devices
The most common cause of faults during installation is the presence of a driver for a
similar, old device. The best solution is to first remove all drivers related to old
devices before installing the new driver. Make sure you only delete programs for old,
unused (similar) devices.
1.
Enter the Windows ‘Safe Mode’. (Press F8 when starting Windows before the
Windows start screen is displayed and select ‘Safe Mode’.)
2.
Click on ‘Start – Settings – Control Panel’ and double-click on the
‘Add/Remove Programs’ icon.
3.
Find all the programs for similar, old devices and remove these by clicking on
the ‘Add/Remove’ button. When in the ‘Safe Mode’, it is possible for some
programs to appear twice. In that case, remove all the programs which
appear twice.
4.
Restart the computer.
3.2
Unlocking the transport lock
Note:
The transport safety lock must first be unlocked before you can
use the scanner.
Carry out the following to unlock the scanner.
1.
Remove the scanner from the packaging and turn the scanner upside down.
2.
Use a small coin (for example, a five pence piece) to unlock the transport
lock by turning it anticlockwise a quarter of a revolution from ‘Lock’ to ‘Unlock’
(see figure 1).
The scanner is now unlocked. If you wish to transport your scanner at a later date,
you can relock the transport lock again by rotating it clockwise to the ‘Lock’ position.
3.3
Installing the TWAIN driver in Windows 98, Windows
ME, Windows 2000 and Windows XP
Note:
The latest driver can be downloaded from www.trust.com/12919.
Check whether a new driver is available and use this for the
installation.
Note:
Make sure all other programs (except Windows) are closed
during the installation.
Note:
When installing the Trust 240H Easy Webscan Gold, you must
first install the software before connecting the scanner to your
computer’s USB port.
1. Start
Windows.
2.
Insert the CD-ROM containing the drivers and the applications into your CD-
ROM drive.
3.
The Trust Software Installer will start automatically (see figure 2). If it does
not start automatically, select ‘Run’ from the Windows ‘Start’ menu. Type
[D:\SETUP.EXE] and click on ‘OK’.
