Easy Scan 9600 Plus
5
3. Connecting
Note:
Turn off the computer before you connect any peripheral
equipment.
Follow the instructions below to connect the scanner to your computer:
1.
Turn off the computer and all its peripheral equipment.
2.
Remove the plug of the printer cable from the parallel port (if
present) located on the back of your computer.
3.
Connect the printer cable (if present) to the ‘Print’ connection at
the rear of the scanner (Figure B, Connector B).
4.
Remove the interface cable from the packaging and connect it to
the parallel port of your computer.
5.
Connect the other side of the cable to the ‘Host’ connection of
the scanner (Figure 1, Connector A).
6.
Connect the cable of the power supply adapter to the scanner
(Figure 1, Connector C).
7.
Plug the power supply adapter into the wall outlet.
Your scanner (and printer) are connected. You are now ready to install
the driver and the applications.
Note:
The scanner is turned on and off automatically. This is
why it does not have an on/off switch.
Figure 1:
Rear of the scanner