TruTech KLV3112A, User Manual

HOW IT WORKS 10

MOUNTING INSTRUCTIONS

MOUNTING INSTRUCTIONS

MOUNTING INSTRUCTIONS

MOUNTING INSTRUCTIONS

MOUNTING INSTRUCTIONS

b) Fold the Mounting Template along the

guideline that is closest to the thickness of
your cabinet overhang.

c) Tape Mounting Template to the underside

of the cabinet with the folded portion of the
Mounting Template flush up against the
cabinet overhang  (see Figure 2).  Go to
STEP 2.

STEP 2.

STEP 2.

STEP 2.

STEP 2.

If your cabinet DOES

DOES

DOES

DOES

DOES have an overhang:

a) Measure the thickness of the cabinet

overhang (see Figure 1).

STEP 1

STEP 1

STEP 1

STEP 1

STEP 1

If your cabinet does NOT

NOT

NOT

NOT

NOT have an overhang:

a) Place the Mounting Template in the desired

location inside or underneath the cabinet
(whichever has less obstructions, and will
be easier for you to reach to drill holes),
flush with the front edge of the cabinet and
tape it down.  Go to STEP 2

STEP 2

STEP 2

STEP 2

STEP 2.

STEP 2

STEP 2

STEP 2

STEP 2

STEP 2

Use an electric drill with a ¼” drill bit (not
included) to drill all four holes marked on the
Mounting Template (see Figure 3). To reduce
splintering, place a small piece of masking tape
over each hole location before drilling.  Go to
STEP 3.

STEP 3.

STEP 3.

STEP 3.

STEP 3.

If your cabinet DOES 

DOES 

DOES 

DOES 

DOES have an overhang:

a) Eight screws are included with this unit, but

you will only need four of them. Select the
screw length which will go completely through
your cabinet bottom, and extend at least 3/
8" past the bottom of your cabinet overhang.

b) This unit includes three sets of four spacers

of various lengths. The spacers can be put
together to form longer spacers to
accommodate various cabinet overhang
thicknesses. Determine the best combination
of spacers which is equal to or longer than
the cabinet overhang thickness.

c) Hold the unit up against the bottom of the

cabinet, and align the four holes on the top
of the unit with the screws. Partially tighten
each screw, but do not fully tighten the
screws until all of them have been started.

d) Gently tighten each screw until they are firmly

holding the unit in place.

(Continued on next page)

(Continued on next page)

(Continued on next page)

(Continued on next page)

(Continued on next page)

STEP 3

STEP 3

STEP 3

STEP 3

STEP 3

If your cabinet does NOT

NOT

NOT

NOT

NOT have an overhang:

a) Eight screws are included with this unit, but

you will only need four of them.  Select the
screw length which will go completely
through your cabinet bottom, and provide at
least 3/8" of thread to screw into the main
unit.

b) Insert the four selected screws through each

hole from the inside of the cabinet going down
(see Figure4).

Cabinet Bottom

Front
edge

Figure 1

Figure 3

Cabinet Bottom

Front
edge

Template

Figure 2

Figure 4

TOOLS NEEDED: 1) Electric drill with 1/4” bit; 2) Phillips-head (cross style) screwdriver.