Did you find what you’re looking for? The Truth Hardware Web site is a great resource
for the latest product and installation information. It’s available at www.truth.com
14
Initialization
The power skylight system is now ready to be initialized. Initialization occurs
automatically when the motor unit receives its first “Open” command.
•
Upon receiving an “Open” command for the very first time after original
power up, the unit will automatically run through an initialization cycle.
Initialization consists of one full open and closed cycle.
•
The “Open” command can be given from any of three control devices:
o
Remote Control (Note: The remote must first be
programmed – see step 11)
o
Wall switch
o
HPI Input
•
During initialization the LED on the motor cover (and on the switch face
plate if installed) will display a “Red” LED.
Note: This cycle is necessary for the unit to establish its operating
parameters which will be stored in permanent memory. Once
permanent memory is established it is unaffected by loss of power of
any duration.
11. Program Remote Control
If a remote control is part of the installation it should now be programmed to
the control unit. Refer to set-up instructions included with the remote control
for proper set-up.
Skip this step if the installation does not include a remote control.
Normal Operation
From the remote control:
To open the skylight:
•
Select “Unit” number (or “all”) for the skylight you want to control.
•
Press “Open” button.
Note: The full open position varies with operating hardware and
curb height of the skylight. The typical stop position is approx. 90%
of full open.
To close the skylight:
•
Select “Unit” number (or “all”) for the skylight you want to control.
•
Press “Close” button.
For an intermediate open position,
•
Press the “opposite” function while the motor is running - the motor
will stop in that position.
Further information on using the remote control can be found in the
instructions packaged with the remote.
