Did you find what you’re looking for? The Truth Hardware Web site is a great resource
for the latest product and installation information. It’s available at www.truth.com
26
•
Indicates normal motor operation. The light will stay lit only while the
motor is running.
2. Motor not running (LED stays lit for 2 – 3 minutes)
•
The cable between the control unit and the motor may have become
disconnected. See step 5.
•
The connector at the end of the black and red wires coming from the
back of the motor may have become disconnected from J2 located on
the small circuit board at the back of the motor assembly.
•
The jumper or screen interlock has been disconnected or has been
removed. Verify connection. See step 6.
Flashing Green:
1. Under normal operation it indicates the rain sensor has been activated.
The light will flash green only while the skylight is closing.
2. Indicates set up mode for the hand held remote. See set up instructions
for the remote control.
Required Maintenance
The required maintenance for your new power skylight system is minimal. To
insure years of trouble-free operation the following maintenance should be
performed:
•
Clean and lubricate the skylight chain. Be sure to use a dry lubricant.
This should be done once a year in non-coastal environments.
•
In coastal environments the chain should be thoroughly cleaned with
fresh water to remove any salt residue. This should be done every 3 –
6 months depending on the severity of the coastal environment. A dry
lubricant should be applied after each cleaning.
•
If the rain sensor is used, it should be cleaned every 3 – 6 months with
a mild detergent.
