52
TruVision 6MP and 12MP 360° Camera Configuration Manual
9. Click
Arming Schedule
to set the arming schedule.
10. Click
Linkage Method
to select the linkage methods. Select one or more response
methods for the system when a region entrance detection alarm is triggered.
11. Click
Save
to save the settings.
Region exiting detection
Region exiting detection function detects people, vehicle or other objects which exit
from a pre-defined virtual region, and some certain actions can be taken when the
alarm is triggered.
To define region exit detection:
1. From the menu toolbar, click
Configuration
>
Event
>
Smart Event
>
Region
Exiting Detection
.
2. Select the
Enable
check box to enable the function.
3. Select the region to be configured from the drop-down list.
4. Click
Area Settings
. Click the
Draw Area
button and then draw a rectangle on the
image as the designated region.
When you draw the rectangle, all lines should connect end-to-end to each other. Up
to four areas are supported. Click
Clear
to clear the areas you have drawn. The
designated region parameters can be set up separately.
Note
: The area can only be quadrilateral.
5. Set the maximum and minimum sizes for valid targets. Targets smaller or larger
than the valid target size are not able to trigger detection.
Max. Size
: The maximum size of a valid target. Targets larger than this will not
trigger detection.
