5
2. Preparing for use
2.1 Electrical connection
Before connecting the machine to the power supply,
check that your supply voltage corresponds with that
marked on the rating label on the machine.
2.2 Connecting the batteries
•
Unscrew the bolts that fasten the tank to the handle
support (Fig 1).
Fig. 1
•
Remove the recovery water tank (6).
•
Connect the battery connectors (Fig 2 & 3).
Fig. 2
Fig. 3
•
Replace the recovery water tank and screw into place.
WARNING -
Make sure that the mains system is
equipped
with an RCD (circuit breaker).
2.3 Charging the batteries
NOTE -
8 hours are required for complete battery charge.
IMPORTANT -
Opportunity / top up charging will damage
the batteries. This will cause run time to fall and overall
battery life will be affected.
AVOID TOP UP CHARGING.
WARNING –
Only charge batteries in a well-ventilated
area.
•
Leave the batteries to charge until the “Green” LED
comes on, then remove the plug and wind the battery
charging lead around the cable holder (Fig 4).
Fig. 4
2.4 Adjusting the handle height
Select the most comfortable handle height using the
adjustment lever (5) on the handle. Release the lever and
lock in position.
NOTE -
By positioning the handle
vertically, it is possible to effect a more thorough cleaning
of corners by rotating the machine on itself.
2.5 Fitting brushes or pads
WARNING –
This appliance has been designed for use
with quality brushes and pads only. The fitting of
inappropriate brushes and pads may affect its
performance and safety.
WARNING -
Ensure the machine
is switched off before adding or changing accessories.
•
Ensure handle (1) is in the upright position and the
squeegee (12) is in the up position.
•
Position the brush (11) on the ground.
•
Lift the front of the machine and remove the polystyrene
support.
•
Position the brush guard (10) above the brush (11).
•
Press the brush motor button (C), start the rotation of the
brush by pressing lever (3) until hearing the coupling
“Click” of the attachment of the brush. Release lever (3)
and press the brush motor button (C) off.
IMPORTANT -
Never allow the cleaning head to rest on
the brush or drive disc and pad when not in use.
2.6 Filling the solution tank
•
Remove the filter from the solution tank opening.
•
Connect one end of the filling hose to a tap and insert
the other end in the solution tank (Fig 5).
Fig. 5
UK only
The supply cord for 230v models is fitted with a plug
containing a 13 amp fuse. Should the fuse require
replacement it must only be replaced by a 13 amp
fuse conforming to BS1362, and the fuse cover must
be refitted. If the fuse cover is lost the plug must not
be used until the correct replacement cover is fitted.
Should an extension cord be used, ensure cord rating
is adequate for the equipment. Do not use extension
cord in coiled condition as this could result in
overheating of the cord. The power supply cord plus
any extension leads should not exceed 30 m in total.
The cross-section of any extension cable wiring must
be at least 2, 5 mm².
WARNING –
THIS APPLIANCE MUST BE
EARTHED.
