6
© TrynEx International 2013 (REV A) F51073A
Operating Instructions
Spreading Tips
The application rate, which is the amount of material spread on a given area, depends on three variables – Vehicle Speed, Spinner Speed and
Auger Speed.
For consistency in spreading results, it is best to drive at a constant speed.
The Spinner Speed changes the spread width. This determines how much area the same material fed by the auger will cover.
Auger Speed changes how much material is fed to the spinner. Changing this will change the amount of material being spread in the same
area.
Wider Spread Patterns will spread the same material over a larger area, so the application rate will be decreased unless you increase your
Auger Speed or drive slower. A Narrower Spread Pattern requires the opposite action: a slower Auger Speed or drive faster.
To maintain your application rate with a wider spread pattern, you can increase your auger speed, drive slower, or spread the area twice.
To maintain your application rate with a narrower spread pattern, you can decrease your auger speed or drive faster.
1
5
2 or 4
3
1
Key
1 Constant Speed. Desired application
rate is set.
2 Increase Spinner and Auger speeds to
maintain application rate with a wider
spread pattern.
3 Decrease Spinner and Auger speeds to
maintain application rate with a nar-
rower spread pattern.
4 Increase Spinner Speed and drive
slower.
5 Increase Spread Width and spread
second pass on the way out of the
parking lot.
EXAMPLES:
Summary of Contents for SnowEx Precision Pro SP-1675
Page 11: ...11 TrynEx International 2013 REV A F51073A Notes...
Page 12: ...133009...
