PROBLEM
CAUSE
SOLUTION
The feeder refuses to run
in forward
-12v.
cable of the
crusher not connected
to the tractor
-Connect
the electric
cable to the tractor
The feeder refuses to run
-Hydraulic plugs not
properly connected
-Hydraulic engine, tractor
distributor or pump defective
-Check the connections
-Inspect or change the
defective part
The machine has difficulty
shredding
-Blades and hammers are blunt
-Spinning of the friction
safety of the transmission
-Sharpen or replace the blades.
Change the hammer pellets
-Inspect the friction safety
Feeding
in
forward
operation is not regulated,
not
even
below
the
VarioStress
intervention
threshold
-Electric
or
hydraulic
problem
-Contact your dealer
The hydraulic oil heats up
quickly and abnormally
-Incompatibility between the
tractor and crusher plugs:
-certain plugs, for instance
those with ball valve, do not
go together well with sockets
with needle valve, resulting
in a bad passage of the
hydraulic fluid through the
assembly
-Install plugs on the machine
side that are suitable for the
tractor
P R O B L E M - S O L V I N G
In this section we have compiled a list of problems, their causes and their solutions, in the
possible case that you meet one.
If you come across a problem that is not covered in the troubleshooting section, please
contact your dealer. Have your user manual and the serial number of your shredder to hand.
Summary of Contents for Saelen GS/COUGAR PTO
