9
Charging takes approximately 1-2 hours. After the LED turns off
disconnect the adapter from the USB port of PC and from the Recorder.
In case of complete discharge of the rechargeable battery, charge it
and re-write configuration onto the Recorder.
3.4 CONFIGURATION RECORDING
To change configuration and to work with recorded files saved on micro-
SD, connect micro-SD card to the PC with Windows operating system via
card reader.
To do this, go through the following steps:
•
Insert micro-SD card to PC using adapter
•
Change configuration using program (see paragraph 3.6)
•
Quickly pull out micro-SD card from PC, insert it to Recorder
and press Status button (right one). LED flashes red then blue and
then turns off. Configuration is written successfully.
3.5 SOFTWARE TO OPERATE THE RECORDER
Specialized software is supplied with the device to change configuration,
set current time and operate with the recorded files (playback, digital
signature check, deletion).
To run this program, launch the Application
RegistratorCfg.exe.
The appearance of the main window is shown in Figure 6.