4
Loading Die-cut Labels
1. Open the supply door by pulling outward on the release buttons on both sides of
the printer.
2. Lift up the peel off enablers on both sides.
3. Pull supply holder tabs apart.
4. Insert a roll of labels. Make sure the supply unwinds from the top as shown.
Note: Calibrate the gap/black mark sensor when changing media. Do not calibrate
the gap/black mark sensor in peeler mode to avoid paper-jams at the peel-off roller.
5. Remove a couple of labels from the liner. Insert the liner through the gap between
peeler bar and peel-off roller.
6. Close the supply door.
7. Press the
button once or twice to advance the labels until the liner is
separated from the label.
Peel off enablers
Label
Liner
Lift
up
the peel off enablers
Push
down
the peel off
enablers
Summary of Contents for 39-0000144-10LF
Page 1: ...Quick Start Guide Direct Thermal Portable Printer ...
Page 2: ...ii ...
Page 14: ...11 P N 39 0000144 10LF ...
