BLUETOOTH MODULE INSTALLATION GUIDE
BT-EM01, BT-EM101
Bluetooth wireless technology is a low-power consuming way to communicate between devices. It has a
maximum range of 30 feet (10m). The Bluetooth device connects to your printer’s serial port and confirms to V2.0
+ EDR of the Bluetooth specification.
Installing the Bluetooth Device to the Printer
Please follow the steps below to install the Bluetooth device.
1. Turn off the printer power.
2. Plug in the Bluetooth device into the RS-232 port.
3. Fasten the device by two screws.
Setting the Communication Settings
For industrial printer, the RS-232 communication parameters can be configured from the LCD control panel by
the following procedures.
1. Turn on the printer power.
2. Enter the main menu.
3. Select Serial Comm. Option.
4. Make sure the communication parameters are set to
115200 bps baud rate, None parity, 8 data bits, 1
stop bit
.
For desktop printer models, the RS-232 communication parameters can be setup following command
Syntax:
SET COM1 115, N, 8, 1
P/N: 39-0000-00LF
Baud Rate
-- Parity --
Data Bite --
Stop Bits
--
Exit
Serial Comm.
Bluetooth device
Screw
LED indicator
Note:
This RS-232 interface of Bluetooth device is used with
the printer only.
