OPERATOR’S MANUAL
34 / HOME MENU
ISO
6
Version 4 UL 2_3 Manual
6011258 Rev C
MODULES
The Module screen identifies modules connected to the CAN
bus. A check mark to the left of each module’s serial number
identifies that the module is active and communicating.
The Module Address (MOD ADDR) column identifies the
module’s position on the implement. Accurate module placement
is required for proper operation.
MODULE LIMITS:
Up to 16 seed sensors can connect to the ISO
6
module.
Up to 8 WSMB can be installed to monitor up to
144 sensors.
Up to 5 WSMB2 can be installed to monitor up to 90 sensors
with quality data.
Each module present on the CAN bus is identified on the Module
screen by the serial number and module type. A label on the
module indicates the serial number and corresponds with the
serial number on the Module screen.
CONNECTING SEED SENSORS TO
ISO
6
/WSMB
Each module address is determined by the order in which
the modules are installed on the implement.
Modules and their respective address appears on the
Module screen as installed on the implement.
Seed sensors must be connected to the ISO
6
or WSMB
continuously and consecutively. Any skipped inputs will
cause an alarm.
Example: Module Address 1 should be assigned to the module
connected to Row 1. Module Address 2 should be assigned to
the module connected to the next set of rows. The assigned
numbering continues until all rows are numbered.
REPLACING INSTALLED MODULES
(AUTO CONFIG)
When an installed module is replaced, e.g. for a defective
module, an auto configuration is necessary to remove the old
module from the system and replace with the new module.
