35
Re-installing the Inlet Assembly
When the photometer is removed from the enclosure, the top of the
enclosure will have an opening unless the Inlet Assembly is
reinstalled. If the Enclosure is to be left outside, follow the steps
below to re-install the Inlet-Assembly column to the mounting ring
from the DustTrak monitor to ensure a waterproof seal on the
enclosure.
1. Remove the mounting ring from the photometer. Save the four
screws for reinstallation of the mounting ring on the photometer.
Figure 33: Remove mounting ring from photometer
2. Install the Mounting Ring from below into the top opening of the
environmental enclosure. Install the Plastic Glide Ring on the
bottom and then the knurled Retainer Ring. Tighten the Retainer
Ring until tight.
Figure 34: Secure retainer ring
Summary of Contents for DUSTTRAK 854030
