1
Ensure that the harnesses are not kinked or damaged as you install them in the car.
Additional harnesses that you install must be secured with cable ties.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead
terminals must be used.
All harnesses must be installed correctly with power position according this
instruction.
The cables/lines are not allowed to be altered, and should be hidden within the car.
The pad must be laid within the fillisters for trimming wires of seats and backrests.
The width of the pad is limited with the fillisters of foam
The heating area is not allowed cut or drilled. There are two rules must be followed as
you cutting the pad:
When a rectangle aperture is needed, the pad must be cut along perpendicular
direction to the electrode tape. The electrode tapes must not be cut off. If the pad is
longer than needed, the pad should be cut at the bottom side along perpendicular
CSH 1 / CSH 2
Installation manual
CAR SEAT HEATER
www.eldibg.com
car audio & multimedia system
