The backrest of heating pad should be unfold as illustrated in
8
The installation of the backrest on the fillisters is the same as
2
&
4
.
There are at least 3mm between the pad and fillisters after the pad is unfolded nicely.
The heating area can not be put inside of any fillisters.
The foam opposite to the temperature controller should be cut into a hole, in order to
level the pad.
If there are fillisters for trimming wires on the seat or backrest, the heating area of pad
within the two electrode tapes should be delineated with pencil or marker pen and cut
into a rectangle aperture with 40mm width as illustrated in
11
.
www.eldibg.com
car audio & multimedia system
