If the scanning failed, "000" will be showed at the lower left corner, switching off
the unit, and checking all connections in good condition and then restart the unit to
scan again. If the scanning will not proceed at all and the data do not appear at all
while driving, you first need to reset the control unit.
Normal use
Idle mode
: start the engine and in idle mode the HUD shows below :
Engine ON/OFF Setting
When unit in normal use : Sliding “Up/Down/OK” button to set the unit power
off mode
1. Sliding up the “On /Down/OK”button
，
the power off model is regular mode
（
Unit system will power off if failed to fetch vehicle data
）
,We suggest to use
this mode if vehicle have the Auto ON/OFF function
2. Sliding down the “ Up/Down/OK” button , the power off model will be in
intelligent mode , the unit will power off if system detect both engine speed and
vehicle are 0
3.The unit default to be intelligent mode .
Restore to factory setting (RESET)
In first time use of this unit, the unit will scan the vehicle communication mode
and locked in this mode. Therefore you have to restore the unit to factory
setting if change to other vehicle. Work the operating procedure as below:
1: switch off the power supply
2: press the OK button and switch on the power supply at the same time.
3: the unit upper right corner shows "0", and lower left corner also shows"0", it
means finish restore setting.
