User Manual B410PT
10
11
3.1 Removing the server blade
WARNING: DO NOT USE TOP THUMB SCREW TO LIFT CHASSIS! These thumb
screws are used only to install and remove the blade only!
Loosen the two thumbscrews that secure the
blade to the chassis. If the thumbscrew is too
tight, use the Philip-head screw drivers to untight-
en it as shwon in figure shown
Slide the blade forward and grasp the cover at
both ends.
Ensure that the work surface is flat and clean to
prevent scratching the computer cover
1
2
3
3.1.1 Removing the blade
Figure 14 Indentify the blade you want to remove
Figure 15 loosen the thumbscrews
Figure 16 Slide out the blade
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives
and the internal system components to cool before touching them.