Type of command
CPR?
To read out preset count value.
Reply
0001000
Reply data is 8 digit decimal value. (Kcts unit)
CPRF?
To read out preset count value.
Reply
0001000
Reply data is 8 digit decimal value. (cts unit)
(If reply data is over 8 digit, the digit is as the count digit.)
3-2-6. Setting and readout of preset timer
Type of command
STPRdddd････
To set preset value dddd・・・・・ in decimal to timer. (ms unit)
Maximum timer set value is 1,099,511,627 ms.
STPRFdddd････
To set preset value dddd・・・・・ in decimal to timer.(μs unit)
Maximum timer set value is 1,099,511,627,776 μs.
Type of command
TPR?
To read out preset timer value.
Reply
0001000
Reply data is 8 digit decimal value. (ms unit)
TPRF?
To read out preset count value.
Reply
0001000
(If reply data is over 8 digit, the digit is as the timer digit.)
3-3. Commands of counter operation
3-3-1. Counter start
Type of command
STRT
Enable counter start.
3-3-2. Counter stop
Type of command
STOP
Enable counter stop.
Synchronous gate data acquisition is ended compulsorily.
3-3-3. Gate in enable/disable
Gate is always made to an on-state, without desorbing a Gate connection cable.
This function is available from "HD-VER 4" or later.
Confirmed the hardware version by the command "VERH?"
Please ask us about Hardware version up.
Type of command
GATEIN_DS
Gate is always turned ON.
A counting can be started irrespective of the Gate status.
Gate synchronous data acquisition cannot be done in this status.
GATEIN_EN
GATE input becomes effective, according to an input state, it becomes
possibility of a counting, or prohibition.
GATE signal synchronism data acquisition is possible in this status.
After power-up, Gate Function is this mode.
GATEIN?
Ask GATE input status.
GATE function is enable, when the reply is EN.
GATE function is disable, when the reply is DS.
17/43
