FRONT PANEL CONTROLS
SE-408N
POWERED MIXING AMPLFIFIER - 6 -
<MASTER CHANNELS>
30. LEVEL LED: Displays output levels of L-ch, R-ch and Monitor. Reduce appropriate
master volume control if system is operating in red zone. Excessive output levels result
in excessive distortion and risk of loudspeaker damage
31. POWER: Power on/off switch.
32. PHANTOM POWER: Co48V equally to pins 2 and 3 of each mic input XLR
connector to provide power to condenser microphones, where applicable. Yellow LED
indicates when phantom power is on. Condenser mics and dynamic mics may normally be
used at the same time without damage but to avoid possible problems, switch phantom
power on only when condenser microphones are being used.
33. PHANTOM POWER ON: When illuminated.
34. PROTECTION: Protection circuit indicator. LED lights when unit has shut down to
protect itself
from damage as a
result of
overheating
which is
generally caused
by output short
or DC voltage.
Be certain to
correct the
problem before
turning system
back on or
damage may
result. Check
ventilation,
speaker wiring
and speaker load.
Speaker load
should not be be
less than 4 ohms,
loads less than 2
ohms will cause
the protection
circuit to operate.
35.EXTERNALEFFECT RETURN- VOLUME
CONTROL.
36. STEREO 7-BAND GRAPHIC EQUALIZER:
Adjusts tonal quality of amplifier output.
37. MASTER-VOLUME: Stereo output volume
control.
38. MASTER-MONITOR: Volume control for send
to external monitor amplifier.
39. TAPE-VOLUME: Input level of tape/CD input
connection on rear panel.
40. TAPE-MONITOR: Adjusts level from tape/CD
in on back panel to monitor mix for playback of
Tape/CD signal to monitors for sing-along with
music source monitor.