REAR PANEL CONTROLS
SE-408N
POWERED MIXING AMPLFIFIER - 7 -
1. EFFECT SEND/RETURN: 1/4" TRS (Tip-Ring-Sleeve) insert-type connection. Patches (inserts) external effect
(compressor, processor etc) or graphic EQ between mixer and power amplifier sections. See diagram for connection..
2. EXTERNAL ECHO RETURN: Unbalanced 1/4" phone jack, stereo return from external effect device.
3. EXTERNAL ECHO SEND: Unbalanced 1/4 " phone jack sends signal to
external effect device from "EFF" mix. Using this output disconnects the
internal effects.
4. MONITOR OUTPUT: 1/4" phone jack send from "MON" mix to external
monitor amplifier.
5. TAPE RECORD: RCA-Type jacks send pre-master fade output to external
recorder.
6. TAPE PLAY: RCA-Type inputs for signal from
external music source such as cassette player, CD
player, keyboard or drums. If source is a cassette
recorder, output and record in should not be
connected at the same time.
7. LINE OUTPUT: 1/4" phone patch to external
amplifier(s) for additional power.
8. FUSE: Holder with 125V 10A FUSE
9. GROUND: If other devices are not grounded as the
SE unit is, grounds must be connected here. To
avoid ground loop noise and oscillation only ground
devices at this point that are not grounded elsewhere.
10. POWER CORD: Nominal 115 VAC verify that the
curcuit is grounded before use.
11.SPEAKER OUTPUT: Consists of 12 AWG binding-
post/banana type connectors and 1/4" phone jacks.
Connect as indicated above.
