-5-
When the pump is delivered, first perform the following checks.
Inspection
While unpacking, inspect the product for damage during shipment, and make sure all bolts and nuts are
tightened properly.
Specification Check
Check the model number to make sure it is the product that was ordered. Be certain it is the correct voltage
and frequency.
If there is any problem with the product as shipped, contact your nearest dealer or Tsurumi representative at
once.
Note:
3 PRIOR TO OPERATION
Product Specifications
Do not operate this product under any conditions other than those for which
it is specified. Failure to observe this precaution can lead to electrical shock,
electrical leakage, fire, water leakage or other problems.
CAUTION
Major Standard Specifications
Fluid
Property
Rain Water, Ground Water, Sand laden Water,
0 ~ 40°C
Pump
Impeller
Close-Type
Shaft Seal
Double Mechanical Seal
Bearing
Ball Bearing
Specifications
Dry type Submersible Induction Motor, 2-Pole
Insulation
Class F
Protection System (Built-in)
Miniature Protector
Leak Sensor (Built-in)
Electrode
Turbine Oil VG32
Lubricant
Connection to Piping
JIS 10K Flange, JIS 20K Flange
Motor
Example of nameplate
1
2
3
4
5
6
7
8
9
10
11
Submersible pump
Built in motor protector
Serial number
Model
Frequency
Max. total head
Min. total head
Max. flow rate
Discharge bore
Phase
Rated voltage
12
13
14
15
16
17
18
19
20
Rated current
Rated output power
Insulation class
Max. liquid temperature
Weight without cable
Speed of rotation
IP degree of protection
Max. immersion depth
Direction of rotation
Accessory Check
Verify that all accesessory items, are include in the package.
Operation Manual............................. 1
If you discover any damage or discrepancy in the product, please contact the dealer where this equipment
was purchased or the Turumi sales off ce in your area.
Note:
