TT8900 OPT
–
Installation and Service Manual
Page 11 of 41
2.
Installation
This section must be read and understood prior to any installation or servicing work
commencing. For further clarifications, please contact Transponder Technologies.
For installation activities, it is assumed the installer possesses previous expertise and training
in Transponder Technologies equipment, particularly T6 Controller based DCAs and Forecourt
Controllers.
Tools Required: The only non-standard tools required to install the OPT is a Post Torx
(also known as Tamper proof Torx) size T30 security screwdriver. This is for the M6
screws that secure the access panel.
2.1
Standards and Safety
It is the responsibility of the installation staff to ensure that all relevant standards and
legislation relating to installation of this device are adhered to e.g. OH&S, electrical wiring codes,
and hazardous area works etc.
2.2
Applicable Standards
The following is a list of some of the standards that are relevant to the installation of the OPT.
Note: This list is NOT complete and the installation technician is responsible for determining
what other standards may apply.
»
AS 3000 “Wiring Rules”
.
»
AS 1940 “The storage and handling of flammable and combustible liquids”
.
»
AS/NZS 2430.3.2 “Classification of hazardous areas” “Part 3.2: Examples of area
classification
–
Vehicle workshops, vehicle parking, fuel dispensing stations and aircraft
hangars”
.
2.3
Safety Issues
This list is provided as a guide to some of the product specific safety issues that need to be
addressed when installing this device. It should not be considered complete.
»
The complete TT8900 OPT tower weighs approx. 140kg, therefore handling precautions
are required.
»
The upper cabinet assembly weighs approximately 30kg. Two people should be used
when lifting it into position within the tower.
»
The TT8900 OPT has an internal Uninterruptable Power Supply (UPS). This means that
even if the device is isolated at the switch board, there will still be voltages present
inside. Before operating on the device, the UPS should be switched off using the switch
located on UPS battery pack and the UPS battery should be disconnected.
»
The door assembly of the TT8900 OPT weighs approx. 10kg. The oil filled struts that
prevent the door from opening too quickly, and restrict its travel, should be inspected
regularly to ensure that they are working and are fastened to the door and cabinet
securely.
