Tiny Audio C3
Operating your In-Car DAB+ Digital Radio Receiver:
1.
Mount the TINY AUDIO C3 In-Car DAB+ Radio receiver to the dashboard
using the provided adhesive holder.
2.
Connect one end of the USB power supply cable to Micro USB socket in
TINY AUDIO C3 and the other end to dual USB car charger. Plug the dual
USB car charger to the car cigar-lighter socket.
3.
Connect the antenna to the antenna jack. ATTENTION! Proper antenna
installation is very important for a good result. See tips page 14.
4.
Turn on the power with the “POWER SWITCH” and the display will show
“Tiny Audio” logo. Use “MODE” button to select DAB+ mode.
5.
For first time use, you need to scan all the local DAB+ channels by pressing
and hold “TX/SCAN” button for 3 seconds
to activate the “Auto Scan”, all
available DAB+ radio channels will be scanned and saved until another
“Auto Scan” is performed. During scanning, a scan moving bar will be
shown in the display to indicate the progress and the total number of
channels received.
6.
Once it is scanned, you can select any DAB+ radio channels by the Tuning
Knob.
Receive signal from the In-Car DAB+ radio through line out cable:
1.
Press and hold “MENU” button to enter menu mode, use Tuning Knob to
search for “Aux IN/OUT Select” and confirm by short press “MENU” again.
Use Tuning Knob to select “Aux-OUT” and confirm by short press “MENU”
button. Short press “MODE” button to exit menu. A headphone icon “ ”
will be displayed at the top of the blue bar.
2.
Connect your car audio stereo speaker “Aux-in” or “Line-in” to the “LINE
OUT” jack on the right-hand side of TINY AUDIO C3 with the provided
3.5mm audio cable.
5
