PD-20001-R1
Stagetracker II User Manual
9
4.5
Stagetracker II™ RadioEye
The Stagetracker I
I™ RadioEye connects to the Stagetracker II™ Net units front panel connections, RadioEye 1
-RadioEye 2-
RadioEye 3.
There are two cable connections, one for power (48V DC), and one for ethernet connection. The label with serial number
and IP-address is found on the backplate of the RadioEye.
Figure 5
Stagetracker II™ RadioEye front cover
Figure 6 RadioEye mounting bracket and cable
connections.
The RadioEye is supplied with two 48 mm half couplers attached to the bracket and one eye bracket for the safety wire.
Secure the RadioEye with a safety wire that is approved for the weight of the RadioEye so that the safety wire will hold the
RadioEye if a primary attachment fails.
Figure 7 RadioEye with drop arm accessories
Figure 8 RadioEye, tilt adjustment handle
To angle and position the RadioEye there are two spring loaded handles on the sides of the bracket. To loosen
the bracket, pull the handle out and turn clockwise and then push the handle back in again and loosen the
handle. Do the opposite to tighten the bracket.
TTA recommends using a drop arm (e.g. a ø48mm half coupler with a fixed ø48mm pipe, as in
) when installing the
RadioEye to ensure that the RadioEye will be positioned beneath other equipment such as light fixtures etc.
