Beijing TT Aviation Technology Co., Ltd.
Add: No.1 TTA Building, Niantou Industrial Park ,Changping District,Beijing, China
www.ttaviation.org
65
7.1 Function Description
Switch
Channel
Top
Middle
Bottom
E
Flying mode
Attitude mode
GPS mode
AB mode
F
AB recording
/
Recording Point A
Recording Point B
D
Home landing
OFF
/
ON
Switch
Channel
Left
Middle
Right
G
Pump switch
OFF
/
ON
H
Terrain following
ON
/
OFF
Power on transmitter: Short press, then long press Power switch to turn it on
7.2 Bind
Before binding, remove all propellers for safety.
Power on drone for 1 second and cut off immediately, repeating this step for five
times. Then power on the drone for the sixth time and keep the power connection.
Drone will enter into binding mode automatically.
Turn on remote controller. Drone will bind the remote controller successfully with
seven beeps from remote controller.
Remote controller need to be calibrated after binding.
Remark: Binding remote controller can not be operated for more than one pair at the
same time. Only one-to-one pairing is allowed.
7.3 RC Hardware Calibration
The following method is to calibrate the channels of RC itself.
1) keep pressing both button C and button D together until turning on transmitter
successfully.
2) After turn transmitter on, give a long press on the button D until hearing continue
beeping.
3) Start to do joystick calibrating:
Move the joysticks around in cycle and make sure they have reached the max extents
/ corner. Leave the joysticks back to center.
4) Move the switches up and down to calibrate them, and back to center finally.
7
Power Button
16
3-Segment Lever F
8
USB1/Image output
17
3-Segment Lever H
9
Battery capacity indicator