©TTP Ventus 2022
company confidential
9
Rev: 220215
5.2
Pump “Flexi Tail” Connector
Disc Pump uses an FFC (flat flex connector) compatible with most 8-way 0.5mm pitch FFC
connectors. The General Purpose Disc Pump Drive PCB has such a connector, and it is important
that the Disc Pump “Flexi Tail” is properly seated in this connector.
Figure 5: Connecting a pump to the Drive PCB
Slide the Disc Pump Flexi
Tail into the connector
housing.
Initially
some
friction is felt, continue
pushing the connector in
until a hard stop is reached
Push the
connector closed,
applying even
pressure to each
end
Visually inspect the connection,
~5mm should be exposed which
would verify that the Flexi Tail is
properly
seated
into
the
connector
Ensure the connector is fully
open, by sliding the brown
section of the connector
horizontally out from the
driver
