Using your Rugged Racers
Your Rugged Racers have been designed so that they can all operate
simultaneously. They use four separate channels on 27MHz frequency. If you
have more than 4 x Rugged Racers, you will have to use them in separate rooms
because all similar colours operate on the same channel.
To switch the Rugged Racers on, move the slide switch under the cars to the
ON position.
To switch the Remote Control on, move the slide switch on the reverse side
to the ON position.
Press the top left button on the Remote Control to move the Rugged Racers
of the same colour forwards.
Press the lower left button on the Remote Control to move the Rugged
Racers of the same colour backwards.
Press the right button on the Remote Control to move the Rugged Racer of
the same colour right.
Press the left button on the Remote Control to move the Rugged Racer of the
same colour left.
The colour of the Remote Control must match the colour of the Rugged
Racer for it to work.
If the Rugged Racers do not move forwards in a straight line, adjust the
straight line adjuster.
When the batteries are low, the Rugged Racers will operate intermittently.
Place them into the docking station to charge the batteries.
Replacing the battery
Using a screwdriver, unscrew the retaining screw and remove the battery
cover.
Remove the battery pack and dispose of responsibly.
Insert new battery pack ensuring replacement battery pack is of the same
type, and inserted with the correct polarity.
Rugged Racers
TM
RUGGED RACERS MANUAL.indd 6
17/03/2015 14:36
