Battery Saving feature:
The Mouse or WAND will auto shut off after 5 minutes when no buttons or mouse movements.
When the LED lights on the Mouse or WAND flash slowly, it indicates a low battery. To turn off the mouse or WAND
manually, press and hold the Guide button or the Power button for 3 seconds.
Device pairing:
At times, the mouse or WAND may need to be paired with the receiver Stick. You DO NOT have to and should not pair
them unless:
1. You have changed the wireless channel using the Setup Software.
2. You get any new replacement mouse, WAND or receiver.
a.
To pair the Mouse with the Stick:
Press the F button and the A button at the same time, the LED on mouse will flashing fast to indicate that it is in pairing
mode. Then press the Wireless Receiver binding button within 8 seconds. A solid light on the mouse indicates the
pairing is complete.
b.
To pair the WAND with the Wireless Receiver:
Press the BACK button and the Guide button at the same time. The LED on the WAND will flash fast to indicate that it
is in the pairing mode. While the LED is flashing fast on the WAND, press the Wireless Receiver binding button. A solid
light on the WAND indicates the pairing is complete.
If you miss pressing a device button or Receiver button during the pair process the device will return back to normal
mode.
Note: You can only pair one device at a time during the pairing process. There is no need to pair the devices unless you
have changed the RF channel or get a replacement device. There is no need to re-pair after you upgrade the firmware.
6
Pairing The Mouse
Pairing The WAND
1. Press BACK and Guide
1. Press F and A
2. Press the Binding Button in 8 seconds
