Safety note
Please note that the tubes for the
Organ Drive
are operated with high voltage. Operate the device only with
the prescribed tubes and the corresponding cover. Do not open the
Organ Drive
yourself, but leave it to a
specialist workshop if necessary.
Make sure that no moisture can penetrate into the housing.
Connector
Connect the cable of the supplied AC adapter to the AC 12V 1A socket. The plug has a bayonet
connection. This is locked by a slight clockwise rotation of the ring and prevents the plug from slipping
out by mistake during operation. Connect the power supply itself to an electrical outlet (230V).
The instrument (organ/keyboard) is connected to the input socket,
the output is connected to your amplifier system (Leslie/amplifier/mixer or similar) to
control elements:
CHANNEL
to switch between channel 1 and channel 2
Channel 1 is indicated by a yellow LED, channel 2 by a green LED
BYPASS
to turn the effect on and off
The
BYPASS
function is indicated by a red LED labelled
BYPASS
.
HIGH
for rough adjustment of the input level
Normal position:
HIGH
(only if the input stage is permanently overloaded, switch off
HIGH
)
VOLUME 1
to control the volume of channel 1
GAIN
for exact adjustment of the input level and for overloading channel 1 (also active for
channel 2)
CRUNCH
for permanently crunchy sound in channel 1 even at lower input levels and to achieve a
very groovy sound
VOLUME 2
to control the volume of channel 2
DRIVE
to control the overdrive of channel 2
DIRTY
to achieve a groovy - slightly dirty sound in channel 2
TREBLE
for raising or lowering the treble in channel 2
PRESENCE
for further boosting of medium and high frequencies in channel 2 (when
PRESENCE
the
TREBLE
- controller has a greater influence)
EXTREME
to achieve extreme but harmonic distortions in channel 2 (with
FACTOR
adjustable)
HARD
for harder distortion (e.g. tube Leslie 122) in channel 2 (with adjustable
FACTOR
)
FACTOR
to control functions
EXTREME/HARD
in channel 2 (only with switched on
EXTREME
or
HARD
active)
OFF
EXTREME
,
HARD
and
FACTOR
are switched off
