6-4
Section 6 - Maintenance -
Ac2/+4
Troubleshooting
Problem:
Finished pack periodically has 1 bale missing when ejected.
Cause 1:
Center gate did not switch sides and two bales entered on some side before switching over to the
other side causing the machine to lose it’s timing.
Cause 2:
Bales are too long, not allowing trip lever to clear bale on second last row.
Suggested Remedy 1:
Check center pivot pin, to ensure it is free.
NOTE:
It is very important to keep gate pivot greased well.
Suggested Remedy 2:
Adjust trip lever pin towards front of machine, and or, readjust cable and rear hook
thread rods.
Problem:
Bale does not pass though side swing arms, causing the machine to jam up.
Cause 1:
Spring tension on swing arms too tight.
Cause 2:
Stop bolt on swing arm not set correctly.
Suggested Remedy 1:
Loosen spring tension or remove side swing arm and clean up pivot pin.
Suggested Remedy 2:
Adjust stop bolt so bale has enough clearance to pass through.
Problem:
Pack does not eject when last bale enters.
Cause 1:
Thread rods on trip levers not adjusted properly or thread rods on rear gate hooks not adjusted
properly.
Suggested Remedy 1:
Adjust thread rods.
Problem:
Finished pack is not neat, last bale is not moved in far enough to line up with other bales in the same
row.
Cause 1:
Trip lever pin not positioned properly for length of bale.
Suggested Remedy 1:
Move trip lever pin one hole to the rear of the machine adjust thread rods and repeat if
necessary.
Summary of Contents for Accumul8
