7-1
Section 7: Troubleshooting
-
Self Loading Balefeeder
BF5000SL
Section 7: Troubleshooting
Round Bale Problems
Problem: The rotors turn, but the bale refuses to turn
.
Cause: The platform is not raised high enough.
Remedy : Raise bed to push bale against both beaters. Refer to
Problem: Crop material jams between top beater and wiper.
Cause: Too much gap between beater blade guides.
Remedy: Adjust wiper guides. Refer to
Problem: Several biscuits coming out at once.
Cause: The bed is too high.
Remedy: Lower the bed. The crop material was baled when wet, reverse beaters 2 turns then
forward again. Refer to
.
General Problems
Problem: The bale is dropping too hard onto platform
.
Cause: Too much clearance between ground and loading fork bale spear.
Remedy : Spear bale lower to ground when loading. Refer to
Loading, pg.5-1
.
Problem: Bale fork does not trip before the bale rests on the platform.
Cause: Bale hits loading bed too soon, not allowing the bale fork weights to trip and pull the spears
out of bale.
Remedy: Spear bale higher when loading. Refer to
Loading, pg.5-1.
Summary of Contents for BF5000SL
