Operation
26
Pos: 49 /Tuchel/Betrieb/Arbeiten mit der Kehrschaufel @ 1\mod_1199689639484_21.doc @ 10273
Working with the sweeper shovel attachment
The adjustment and handling of the operating elements may vary
from each other depending on the host vehicle used. Observe the
operating manual of the respective host vehicle.
000099
1
2
1. Use the grab handle (1) on the host vehicle and the non-skid
stepping surfaces (2) on the sweeper shovel attachment for
getting onto and off of the host vehicle.
2. Assume the proper sitting position in the host vehicle and
fasten the seat belt.
3. Raise the sweeper shovel attachment from the ground.
4. Drive the host vehicle to the working site.
Adjusting the sweeping profile
b
= 6 - 10 cm
000065
We recommend adjusting the sweeping profile as follows to
achieve the best possible results:
The contact surface between the sweeper cylinder and ground
should have a width (b) of 6 – 10 cm.
1. Check the sweeping profile:
– Place the sweeper shovel attachment on on level ground.
– Allow the sweeper cylinder to rotate at the position.
– Bring the sweeper cylinder to a standstill and raise the
sweeper shovel attachment.
– Measure the width (b) of the cleaned area.
If the width (b) is too small, increase the sweeper cylinder contact
pressure to the ground:
STOP
000064
1
2
The contact pressure adjustment is made using the set screw (1)
and must be carried out evenly on both sides of the sweeper
shovel attachment.
2. Loosen the counter nut (2).
3. Unscrew the set screw (1).
Unscrewing the screw = reducing the contact pressure
Screwing in the = increasing the contact pressure
4. Check the sweeping profile again as described in step 1.
Summary of Contents for Big
Page 1: ...1 0 2008 02 01 Instruction manual 000050 Sweeper shovel attachment ...
Page 54: ......
Page 55: ......
