Safety
19
Emergency lowering
If the engine or hydraulic system malfunctions, the accessory
equipment is lowered to the ground by the operation of the lift /
lower control lever.
Turning off of the machine
Turn off the machine on level ground. Lower the equipment to the
ground completely.
Turn off the engine, activate the holding brake and always remove
the ignition key and close the ignition switch with the locking cap.
See also
"Before leaving the machine", page 14
.
Transporting
Loading and transporting
Always load the machine without accessory equipment attached.
Turn off the engine, activate the holding brake, always remove the
key and close the ignition switch with the locking cap.
Use only a fork lift or a wheel loader with stacker equipment (fork
prongs) to lift the vehicle onto the loading space.
Adjust the prongs so that the prongs can be positioned sufficiently
wide enough apart between front and rear axle, see dimension
"X" in the adjacent drawing.
Drive with the prongs underneath the hydraulic tank without
damaging the bleed screw (1) of the hydraulic tank in the process.
Place suitable cushioning material (rubber mats) underneath.
Secure the machine sufficiently on the prongs.
Follow the transporting instructions from the operating manual of
the fork lift or wheel loader manufacturer.
Position the machine correctly onto the transporting vehicle and
secure the machine onto the loading space using belts.
An inadequately secured machine can shift during transport and
fall from the transporting vehicle. Secure the machine properly.
1
X
000047
