Operation
36
6
Operation
Placing into operation
Before placing the machine into operation, every operator must
have carefully read and understood the available operating
manual as well as the operating manuals for the combustion
engine and the accessory equipment.
WARNING!
Damage or defects to the machine or to the accessory
equipment can lead to accidents.
•
If defects are found during the following test, the
machine may not be operated until it has been
properly repaired.
•
The machine may only be operated in a technically
sound state and for its intended purpose in
accordance with regulations.
ATTENTION!
Damage to the machine thorough excessive loads.
•
Observe the maximum axle load limits.
Break-in time
The following guidelines apply during the first 50 operating hours:
ATTENTION!
Damage to the machine.
•
During the first 50 hours of operation, 70% of the
full load may not be exceeded.
•
Choose a gentle driving and working method. However, do not
break-in the machine too timidly since otherwise an
unfavourable operating temperature is reached.
•
Do not use the engine continuously at the highest speed.
•
Increase the load at alternating speeds.
•
Comply with the maintenance schedule.
