920.1020.12
12
STEP 4 Cont.:
OPTIONAL - PUSH ARM INSTALLATION WITH
INCREASED SPRING TENSION
•
The door shoe and short arm comes pre-assembled - it is not necessary to take the assembly apart.
•
Install the door shoe per the door hinge / pivot configuration - see below:
o
Hinge Hung Doors: Centerline of door shoe at 13.5" in from inside of hinge jamb
o
Center Pivot Doors: Centerline of door shoe at 16" in from inside of pivot jamb
o
The horizontal centerline of the door shoe will be at 2" below the bottom of the back-plate
o
Do NOT install the primary arm until instructed to do so
HINGE HUNG
CENTER PIVOTED
Summary of Contents for SW10
