10
INSTALLATION INSTRUCTIONS
& WARNINGS
INSTALLATION INSTRUCTIONS
INSTALLATION WARNINGS
READ THE IMPORTANT INFORMATION
ON THE FRONT OF THE BARBECUE.
This barbecue is designed and approved for
outdoor use only.
Be mindful of the location of the installation of
the barbecue.
If you are using the roasting hood it is better that
the prevailing wind blows into the front of the
BBQ during cooking.
NOTE:
Strong winds blowing into the back or
across the back of the hood whilst cooking with
the hood closed can cause overheating of the
BBQ. The Roasting Hood is designed so that Hot
air from inside the Roasting Hood is released
through the vent in the top of the Roasting
Hood when it is shut while roasting.
Strong winds can prevent the hot air escaping
out of this vent and may even in some cases
push the hot air down and out the front of the
base of the BBQ Fascia where the cold fresh air
is designed to enter the BBQ Body.
This choice of installation can cause the front of
the BBQ to get unusually hot and can damage
the ignition system and control valves.
The intended use of this barbecue is to be
installed onto a Tucker GTR Cabinet Trolley.
Be sensible about the location of your
barbecue.
The barbecue must be located on a solid and
level surface that can safely support the BBQ.
The Cabinet Trolley is fitted with lockable
Stainless Steel Castors, when you have your BBQ
installed into position, the brakes on the Castors
must be locked to avoid the Cabinet Trolley
from moving during use.
Do not locate the barbecue near combustible
materials or surfaces, either above or around
the barbecue such as overhanging trees,
bushes or flammable liquids and the like.
Do not obstruct any of the air ventilation
openings on the front of the barbecue.
Do not use this appliance indoors or on marine
craft.
This appliance shall only be used in an above
ground, open-air situation with natural
ventilation, without stagnant areas where
gas leakage and products of combustion
are rapidly dispersed by wind and natural
convection.
Any enclosure in which the appliance is used
shall comply with one of the following:
•
An enclosure with walls on all sides, but at
least one permanent opening at ground
level and no overhead cover.
(figure 1)
•
Within a partial enclosure that includes an
overhead enclosure and no more than two
walls.
(figure 2 and 3)
•
Within a partial enclosure that includes an
overhead cover and more than two walls,
the following shall apply.
(figures 4 and 5)
•
At least 25% of the total wall area is com-
pletely open.
•
At least 30% of the remaining wall area is
open and unrestricted.
•
In the case of balconies, at least 20% of the
total of the side, back and front wall areas
shall be and remain open and unrestricted.
