16
CONNECTION OF A GAS CYLINDER TO
THE BARBECUE IS AS FOLLOWS
The hose assembly connection to the appliance
is fitted by the manufacturer.
WARNING:
there must be no naked flames in
the area when connecting the barbecue to a
gas supply.
•
Attach the regulator to the gas cylinder by
tightening the wing nut on the regulator firm
-
ly by hand.
•
Once connected, leak test the connections
by brushing a solution of soapy water around
the joints and gas cylinder valve.
NOTE:
You must have the control knobs in the
off position and have the gas supply on at the
cylinder valve to test for leaks.
Photo of what a typical leak looks like.
If bubbles appear around the connections,
you have a leak.
GAS INSTALLATION AND
LEAK TEST PROCEDURE
Turn off the gas supply and tighten or re-seal
the connection.
Leak test the connections again
Photo of what a good connection looks like
i.e. no bubbles.
If leaks are still present do not use the barbecue,
contact the place of purchase or your local
dealer.
The GTR Cabinet Trolley has been designed
so as the Gas Cylinder can be stored securely
inside the Cabinet. There is a securing chain at-
tached inside the right hand Cabinet Doors and
a manual lighting match holder is also attached
to the chain.
For the attachment of an S Wok Side Shelf you
must first
turn off the gas supply
. Remove the
existing trolley side shelf and then disconnect
the existing hose and regulator attached to the
BBQ Gas Inlet.
Now re-connect the hose and regulator to the
Gas Inlet on the right-hand side of the Wok
burner Manifold.
The Short Wok Hose supplied with the Wok must
be connected to the outlet on the left hand
side of the Wok Burner Manifold and the other
end of the Hose must be connected to the BBQ
Gas Inlet.
The hose connections must be connected firmly
with a spanner.
OPTIONAL GTR S SIDE SHELF WOK BURNER
INSTALLATION.
