Tuff Birds
Super Tough Wings & Planes
Micro BEE
Specifications:
Ÿ
WingSpan: 600MM
Ÿ
All-Up-Weight: ~ 200gms
Ÿ
CG Location:
130MM back from Nose Tip.
What's Included:
Ÿ
2 EPP Wing Panels in Wing Beds
( Left + Right )
Ÿ
Laser Cut Aircraft grade Plywood sheet
(Motor Mount, Control Horns & Battery Tray )
Ÿ
Corrugated Plastic 3MM Winglets ( 2Nos )
Ÿ
1ft x 6ft 1.7Mil Lamination Film.
~120mm Pushrods
Linkage Connectors
Ÿ
5x250 mm Carbon Fiber Strip
Ÿ
Velcro
Ÿ
Paper Knife
Ÿ
Elevon Throw Gauge
Ÿ
Instructional Manual
Ÿ
2 Nos
Ÿ
2 Nos
Requires:
Ÿ
4-6 Channel Programmable Radio (Tx-Rx)
Ÿ
1000-1400mah 2S Lipo
Ÿ
6Amp-12Amp Brushless ESC
Ÿ
2 Nos 5gms-9gms Servo
Ÿ
Micro Brushless Motor (12-20gms)
Ÿ
5-6inch Propellor
Building Tools:
Ÿ
Hot Glue Gun and Glue Sticks
Ÿ
Cyanoacrylate Glue ( FeviKwik etc )
Ÿ
Screwdrivers & Allen Key
Ÿ
Paper Tape & Clear Packing Tape
Ÿ
An Iron ( If Laminating )
Ÿ
Soldering Iron and Solder Wire
Ÿ
Ruler , Pen and a Flat Working Table
Congratulations on your purchase of the
TuffBirds MicroBee EPP 600MM Flying Wing.
We hope these build instructions will help you
complete the build easily. Though the build
itself doesn't take much time, just be sure to
double check everything before cutting and
glueing.
Before flying, do the preflight checks
thoroughly, and we hope you will have a great
time flying the Micro Bee.
1
Ver 1.0 12 May 2018
600MM Flying Wing
goo.gl/Vrqb9b
Build
Video
:
