fabrics leather
Urethane
3mm
Nylon PP
2--3mm
Operation:
1.Remove the blade and wrench needed.
2.Place the blade into the handle of the fixture, with the wrench.
①
Please note that the consistent direction of the blade and the
handle switch, to avoid anti-loaded blade.
②
Put the blade into the bottom of fixture to prevent loose during
use, as well as to maximize its effectiveness.
③
Fix the blade with wrench, you can not wring once in the end,
many times the appropriate efforts to tighten (use excessive force
to tighten the screws will reduce the life of the screws and clamps).
3.Use the cable to connect the host with handle.
4.Please turn pressure adapter into a power strip, then the mains
plug to turn pressure adapter (220V to 110V adapter must be used,
otherwise it will burn).
5.Open the computer back power switch, power indicator lights.
6.Hold the handle, hold a finger switch on the handle (handle lights
up), the alignment of the parts to be cut, cut, release the switch is
