11
D. GEAR SECTION DISASSEMBLY
1. Drain the oil by removing the plug (31)
located on the bottom of the end cover (3).
2. To disassemble the gear section, remove
the Intelliguard™ (21) from the end cover (3)
by removing three capscrews (6). Inspect
the gear teeth on the Intelliguard™ (21) for
wear. The Intelliguard™ system is not
serviceable in the field. Return to an
authorized dealer for service.
3. Inspect the o-rings (33 & 99) and replace if
necessary.
4. Remove the input gear set (22), along with
the inner and outer thrust washers (34).
Inspect parts and replace if necessary.
5. Remove the secondary gear set (23) and
sun gear (7). Inspect and replace if
necessary.
6. Remove the secondary gear housing (9) by
removing the eight capscrews (35). Inspect
the o-ring (36) and replace if necessary.
The housing is very heavy.
Use caution when removing it.
7. Remove the sun gear (8).
8. Rotate the thrust plate (24-7) into alignment
with snap ring (24-8). Remove the snap ring
from the groove on the output shaft (20).
9. Remove the output gear set (24) and thrust
washer (38). Inspect the parts and replace it
if necessary
Summary of Contents for RUFNEK 130
Page 10: ...10 CLUTCH INSPECTION...
Page 27: ...27 VISCOSITY CHART...
