16
1. Install the bushings (48) into drum
(52) and clutch (53). Install the drum
(52) onto the output shaft (49).
2. Install the thrust washer (54). Tap
the keys (50) into the output shaft
(49).
3. Install the sliding clutch (55) and end
bracket assembly onto the output
shaft (49), lining up the yoke with the
grooves in the sliding clutch (55).
Attach the end bracket to the frame
using four capscrews (29), washers
(26), and nuts (25).
CLUTCH POSITION INDICATOR ADJUSTMENT
(FOR RUFNEK WINCHES ONLY)
Make sure that the sliding clutch (55) is fully engaged and that the yoke assembly (109)
is not binding on the drum clutch. The lugs of the yoke MUST be centered in the groove
with the clutch fully engaged in order for the clutch position indicator to be properly
adjusted (See FIG-1)
The switch is a normally-open electrical switch that is actuated by disengaging the
clutch which closes the circuit.
With the clutch fully engaged, adjust the switch in until the warning device is activated,
then back-out 1/4 turn to deactivate the warning device.
Tighten the jam nut against the clutch bracket to secure the adjustment.
Test the switch by fully engaging, then disengaging, the clutch. The warning device
should activate while disengaging the clutch pivoting no more than 3°.
CLUTCH AND DRUM ASSEMBLY
CLUTCH AND DRUM ASSEMBLY
CLUTCH AND DRUM ASSEMBLY
CLUTCH AND DRUM ASSEMBLY
FIG.-1
FIG.-2
55
NUT
109
SWITCH
