15
MODEL
MODEL
MODEL
MODEL 34
34
34
34 BRAKE
BRAKE
BRAKE
BRAKE ASSEMBLY
ASSEMBLY
ASSEMBLY
ASSEMBLY
1. Press the oil seal (55) into the brake
housing (31). Attach the brake
housing (31) to the gearbox with six
capscrews (56) using gasket (52).
2. Install the brake drum (83) and key
(82) onto the worm shaft (57).
Secure the brake drum with the nut
(85) using the lock washer (84).
Bend two tabs of the washer (84)
over the flats of the nut (85).
3. If removed, reattach the cam (53) to
the
brake
cover
(87)
in
the
orientation
needed
for
your
application using two capscrews (26)
and washers (29).
4. Install the brake cover (87), cam
(53), and brake shoes (86) into the
brake housing (31).
5. Secure the brake cover (31) using
four capscrews (30).
6. Adjust the brake using the procedure
on page 8 of this manual.
RUFNEK
RUFNEK
RUFNEK
RUFNEK 30
30
30
30 BRAKE ASSEMBLY
BRAKE ASSEMBLY
BRAKE ASSEMBLY
BRAKE ASSEMBLY
1. Press the oil seal (90) into the brake
housing (91). Attach the brake
housing to the gearbox with eight
capscrews (89) using gasket (110).
2. Install the key (92) and coupler (108)
onto the worm. Next, install the
clutch/driver assembly (Items 93,
101, 106, and 107), onto the coupler
(108).
3. With the retaining ring (93) on the
clutch driver (101). Install the stator
plates (104) and friction discs (103),
as shown below.
4. Install the spring (105).
5. Install the adjusting nut assembly
(assembled items 97, 98, and 99)
into the brake cover (96) and attach
the brake cover to the housing (91)
with eight evenly installed capscrews
(94).
6. Install the drain plug (100) into the
bottom of the brake cover (96).
7. Fill gearbox and brake with proper
oil. Refer to winch maintenance
section of this manual for oil type and
amounts.
8. Adjust the brake using the procedure
on page 8 of this manual.
