17
ASSEMBLY
GEARBOX ASSEMBLY
1. Press the bearings (54) onto the
worm (57) then install the worm and
bearings into the housing (61).
2.
For winches driven by a hydraulic
motor:
Press a new oil seal (94) into the
motor adapter (95). Attach the motor
adapter (95) to the housing (61) with
six capscrews (96), using gasket
(52). Install the motor (90) with two
capscrews (92), using gasket (93).
For winches driven by a PTO
sprocket and chain:
Press a new oil seal (55) into the end
cap (51). Attach the end cap (51) to
the housing (61) with six capscrews
(56), using gasket (52). Install the
key (58) onto the end of the worm
(57).
3. Install the keys (70) into the output
shaft (68).
4. Slide the carrier (72) onto output
shaft over the keys (70). Install the
spacer (73) using two pins (74).
Slide the gear (75) and the other
carrier (72) onto the shaft and secure
with twelve capscrews (71), nuts
(26), and washers (30).
5. Slide the bushings (69) onto both
ends of the shaft (68).
6. Install the output shaft assembly into
the housing (61).
7. Install both gaskets (79) onto the
housing (61). Attach the cover (76)
to the housing, using capscrews
(3 & 46), nuts (20 & 24), washers
(19 & 23), using gaskets (79).
