4
CABLE CONSIDERATIONS
As the number of layers of cable on a winch increases, the rated
capacity of the winch goes down. If you are operating at near the
top of the drum flanges, the effective rating of the winch is about
half of what it is on the first layer. You should therefore, only
keep as much cable on the winch as you need for your job.
Never use larger or smaller cable on your winch than is
recommended for it. The use of larger cable will not allow you to
pull larger loads and may, in fact, break easier than the proper
size cable. The use of smaller cable may overheat the winch due
to increased running time with more cable.
The following chart shows the recommended cable sizes for
Tulsa Winches
Winch Model
Cable Size
506W
7/16”
707W 1/2”
1200W 9/16”
1500W 5/8”
3541RL 3/4”
RN45P 3/4”
RN60P 7/8”
RN80P 1”
RN100P 1”
RN130P 1
1/4”
Consult your local cable
supplier for recommendation
on the best type of cable and
hardware to use in your
specific application.
WARNING: CABLE ANCHORS
ON TULSA WINCHES ARE
NOT DESIGNED TO HOLD
THE RATED LOAD OF THE
WINCH. YOU MUST KEEP AT
LEAST 5 WRAPS OF CABLE
ON THE DRUM TO INSURE
THAT THE CABLE DOES NOT
COME.
