6
GENERAL DISASSEMBLY
A. MOTOR DISASSEMBLY
1. Drain the oil from the brake assembly by
removing the plug (81) from the bottom of
the brake cover (2).
2. Remove hoses (4, 54, 56, 77, & 80).
3. Remove the counterbalance block (76) and
the manifold block (93), from the motor by
removing the four cap screws (106).
4. Remove the motor from the winch by
removing four capscrews (88).
5. Remove the counterbalance valve (108)
from the counterbalance block (76) and
inspect the metering hole to make sure it is
not obstructed. Also, inspect the o-rings on
valve to insure that they are not flat or cut.
Replace if necessary.
6. Motors and counterbalance valves are not
serviceable in the field. Return them to an
authorized dealer for service.
7. Inspect o-rings (98) & (107) for damage.
Summary of Contents for Rufnek Intelliguard 80
Page 9: ...9 CLUTCH INSPECTION ...
Page 26: ...26 VISCOSITY CHART ...