Tumbl Trak™
sales@tumbltrak.co.uk
www.tumbltrak.co.uk
44 (0)2971 167 949
5
Fig. 6
Fig. 7
2.
Using the Springing Tool
This model has been designed for easier use. The bent
end of the thicker rod fits in a frame hole one down
from the hole into which you want to place the spring.
Use the smaller hook to stretch the spring onto the
tool handle. With your other hand, help place the
spring into the desired hole. **
Watch your hands!!!
You should use gloves (See Fig. 6).
(Watch this video for a demonstration on how to use
the springing tool)
https://www.youtube.com/watch?v=Qo4vp_kDFUsl
3.
Attaching the Frame Pads and End Caps
A.
Attach the pressure sensitive loop Velcro on the
outer edge of the holes on the Porta Trak rails
leaving 6” extra at each end to attach the endcaps.
B.
Align the pre-sewn Velcro on the pads with the
Velcro strip on the Porta Trak rails.
C.
Make sure the springs, frame, and bed flaps are
covered by the pads.
D.
Attach an endcap to each of the four corners of the
Porta Trak.
E.
Use the extra 6” of Velcro to wrap around the
endcap and fasten the Velcro to the underside of
the rail (See Fig. 7).
4.
Folding the Porta Trak
You will need to remove the pads on the frame
before
folding.
Folding the frame with the pads still
attached may cause the hinge to break.
Two or more people are recommended to lift the end of the
Porta Trak, make sure to check for overhead clearance.
5.
Transporting the Porta Trak
After the unit is folded, lift the folded Porta Trak onto the side with the wheels attached. The unit
should be slowly rolled when moving. To open, again use two or more people. The pads will need to
be put back on when you set it back up. Reverse procedure to setup after transference.
Be very careful when folding and transporting any Porta Traks. Always use appropriate assistance.
Fig. 7
