MANUAL
|
FRONT HUB MIG70
www.tune.de
As of May 2015
Page 6 of 9
The cleaned bearing seat gets covered with a thin layer of
glue
3
. The bearing gets pressed in with some light hits
from a hammer
fig. 8
, using the correct sized fitting stamp
fig. 7
.
Pay attention to not cant the bearings and always only strain
the outer ring of the bearing.
5
Installing a new bearing
Needed tools:
• TT08.1
No. WZ0200
• TT08.14
No. WZ0209
• plastic hammer
• glue
2
fig.7
fig.8
TT08.1
TT08.14
fig.6
fig.5
4
Removing the bearings
Needed tools:
• TT08.1
• TT08.2
•
TT08.2
Place the hub on the main tool TT08.1.
Now the bearings can be pushed out us-
ing the tool TT08.2 and a plastic hammer.
Always dispense the force all around the
bearing to not damage both the bearing
and the hub body.
fig. 5 + 6
